« Tippmann A-5 review | BMW F650GS Dakar (Off-roading with a shaft drive?) »

Mounting the Q-loader on a Tippmann A-5

Here is a mock up of try #1. Rejected, no clearance between the back of the Q-loader pod and the face mask.

This is a mock up, a Simpson strong-tie was used to hold the Q-loader in place.

The mounting bracket attaches under the front handle.

A side view of the Q-loader on the A-5.

This would not be a bad mounting location if the Q-loader wasn't as long. The guys at RAP4 are making a custom Q-loader mounting bracket that would replace the Cyclone loader and mount directly to the right side of the A-5. This extends the width of the A-5 slightly giveing it a slightly larger horizontal profile, and probably requires the Q-loader custom mounting socket. Rumor is it'll be ready in a month or so @ about $30.

Coming soon - Part 2, Cyclone feeder + Q-loader

Posted by John Seaman on September 2, 2005 9:57 PM |

Post a comment

(If you haven't left a comment here before, you may need to be approved by the site owner before your comment will appear. Until then, it won't appear on the entry. Thanks for waiting.)